Rev-A-Shelf Double 27 Qt Pull Out Chrome Wire Trash Can Container Bin Bottom Mount for Kitchen Cabinet with Full-Extension Slides, White, RV-15PB-2 S

It took me a long time searching for this product. There are a lot of competing products that I am sure offer great functionality but I would say that this is the one. The fact that it can fit two decent sized trash cans, one of which I use exclusively for recycling is one of the main selling points for this product.I also like the color since white is usually a clean finish and a color that goes well in most kitchens. The installation couldn't be easier. I simply used a power drill, which wasn't necessary but it made the job much easier when it came time to drill the mount down with the screws that are supplied in the packaging. So just to clarify, a power drill is not absolutely necessary to install this product, a standard screwdriver and some elbow grease is more than enough to bolt down the mount.Lastly, the track that the trash cans sits on allows you to easily slide the mount and trash cans out when you are looking to dispose of waste and in when you're looking to store the trash can back in its place. I was amazed to see just how far out the trash cans come out which is another highlight of the product beyond the fact that it is extremely sturdy. I highly recommend this problem.

This is exactly what I was looking for. The dimensions are as advertised--it fit perfectly into the cabinet I measured for it. Installation was very easy. The product arrives completely assembled. All you have to do to install it is:1. Place the entire unit with the bins into cabinet to verify it fits and the door can close.2. Remove bins and align sliding tray square with cabinet.(Optional) 3. Mark locations for pilot holes (one for each corner bracket), remove sliding tray, drill pilot holes, place sliding tray back in cabinet.4. Secure sliding tray with 4 screws. Slide tray out and place bins back in it.The sliding shelf is screwed into the bottom of the cabinet only, not the sides. Therefore the cabinet's exact width isn't too important (as long as it's wide enough), and there is no measuring or leveling required. It helped to drill a pilot hole for each screw because it's difficult to get a good grip/angle inside the cabinet to self-drill the screws without doing this, especially in the back.Be aware that the 2x 27 qt bins are smaller than most trash cans/bags. This is the only unit with 2 bins that would fit in the cabinet I wanted to use it for, so I accepted this. There is a single 35 qt version if you'd prefer a single, larger bin in the same size unit.Again, this is a great product.

Really nice quality. Works great in RV. But there are very few recycle bins in RV parks and camping grounds.

We are remodeling our kitchen and there will be no where to put the garbage can. This handy unit was the perfect fit - literally! It is fully assembled and fit right into our 15" cabinet. The bins are a little on the small side, but with one for garbage and one for recycling, it should be sufficient for us two empty nesters. I especially like that there is a little divider bump between the cans to keep them in their place. The sliding mechanism is very smooth and locks into place when you push it in. We are going to try it for a while without the door mount, but happy to know we can order it in the future if we decide we want it.

This was the easiest install ever. Also the dimensions were right on. Whenever I have to fix something or replace something in my home it’s always multiple trips to the hardware store.Now to fix my leaky sink…..🔧

Product as described and working perfectly. I would send 4 more screws. My only takeaway.

This pull out seemed to be the ONLY trash pull out that made the most use of our cabinet for trash. Others only came with one bin and wasted the back half of the cabinet. The installation was much more challenging than the instructions indicated. I've purchased Rev-a-shelf cabinet pull outs for our last home, and they felt like such a high quality investment. The pulls on this one don't glide nicely, and they feel quite clanky and loud. Overall, I'm happy to have a hidden trash can, but disappointed in the quality in comparison to other products and drawer slides.

10 years ago a 60 lb dog ran into my trash cans while the shelf was pulled out. It has not worked properly ever since and even after bending the metal back it leaned to one side. I finally decided to replace the broken shelf and found this item that looked almost exactly like the old one other than the rails looked a little wider and they had bearings in the rails instead of just sliding like the 20 year old broken one had. To my amazement, the new system had the exact same mounting brackets as the old one and the holes lined up exactly so all I had to do is replace the screws. No holes to drill and it works much more smoothly than the old one, even before it was broke. So, my old one was probably made by the same manufacturer that realized they needed to improve the rails from their 20 year old model.