5mm x 20M (0.2in x 65ft) Conductive Cloth Fabric Adhesive Tape, Faraday Tape for EMI Shielding, Interference Signal Blocking, Laptop Mobilephone LCD Repair, Cable Wire Harness Wrapping

I didn't need much of this so I wanted to find a small quantity at an affordable price and this fit the bill. I was replacing some LED back-lights of our LCD TV and the conductive tape that was already there lost it's adhesive strength when taking it off. This Gennel brand tape was the perfect replacement.

Adheres fine on most surfaces. Quality seems fine. If you are using this to wrap thick wires or surfaces you may want to go with wider width than 10mm

This tape works VERY well as a substitute for the copper tape that would normally be used with the Chibitronics "circuit stickers". Appears to have much better conductivity on both sides (especially the adhesive side.) This tape will allow me to reliably and securely connect a "Chibi-Chip" directly to the paper, rather than using the somewhat clunky "Chibi-Clip". Also "folds" to make turns (as does the copper tape.)I am using the 5mm tape for connections to the Chibi-Chip pins, and the 10 mm for a "ground return" back to the Chibi-Chip.For important applications (e.g., work of art, as opposed to quick demo) I will be using this cloth tape instead of copper tape.

Used to make a Faraday can. Much easier than removing old gasket and replacing with expensive gasket. It worked during testing for a gasketed 55 gal drum and a 50 cal ammo box. Great product, but must have a gasket already in place.

Was a quality product as represented. Used as Emp shield gasket for garbage can lid. Put one piece in corner of trash can lid and second piece went over top and lapped corner piece so rim of garbage can can slide over corner piece and not dislodge it. Will tell you how it works after first Emp. LOL’s

The adhesive side does read as conductive when tested with a multimeter, but with higher resistance than the non adhesive side... I *imagine* it still works well in sealing in/out emf (edit to add: I mean RFI, not emf), but have nothing conclusive to offer on that front. I'm shielding cables in UAVs with it.

Perfectly conductive tape. I love that is so so forgiving if you put it on the wrong spot and need to pull it up and move it. I would by this again when I run out.

This worked so much better than I expected. I used this to get rid of some bad emf pickup on my xlr microphone.

Tape worked great. I used it to cut down on humming noise from the power cord on a non-shielded sub woofer.

Just the material i was looking for !