QTEATAK 5Pcs AC 250V/15A, 125V/20A Red Light Illuminated LED On/Off SPST 3 Pin 2 Position Mini Boat Rocker Toggle Switch Snap for Car Boat

Fits perfectly where the OBC light is on the club car DS

As advertised..

Perfect fit for my pedestal grinder. Back up and running. Pack of 5 gives me spares just in case. Good value.

Bench tested all rockers and they worked.

Switches as described and does the job.

The switches work, but they’re not green. That’s why I bought them, and to replace the flickering switches on my power unit controller. I wish I would have checked before I installed them (9 switches) because I would have sent them back. They glow orange, almost the same as the red switches they replaced.

Product was delivered the next day after ordering.Package was intact. No obstructions. Switch was installed and worked perfectly. Only needed one switch but the pack was very affordable/reasonable price for 5 of them. Overall product is great.

There has been much buyer feedback about wiring on this switch – and rightly so. The wiring diagram from the seller is confusing; and incorrect I think.So I tested the switch using the ohms and diode test modes on my bench meter. I numbered the lugs 1, 2, 3 consecutively; with the brass lug as number 3.The 1st attached drawing shows my inferred switch internal contacts configuration. The lamp appears to be a diode connected internally as shown with lug 3 positive and lug 2 negative. When I tested just the LED; it works for Voltages from 5 V up to 24 V. It’s pretty bright at 24V; but only draws 10 mA.Because of the direction of the internal diode - I determined that switching the high side of the circuit (switch between V+ and before the load) doesn't work correctly, and confirmed it in testing. It seems THE LED IS IN BACKWARDS FOR A HIGH SIDE DC SWITCH OPERATION !!!The attached images #2 & #3 show a high side switch and low side switch configuration respectively. Both approaches successfully turn on power to the load; but the high side switch approach fails to turn on the LED as Lug #3 has to be positive with respect to lug #2 for the LED to work when the switch is on - and with this configuration both Lug 2 and 3 are at V+ when the switch is on. The low side drawing – image #3 – shows the correct wiring for the switch to function with LED illumination.When turned off, the low side switch configuration opens the ground side of the circuit and leaves the + side connected to the load; which is not really desirable. But other than that – it works quite well with this ground side wiring.